41
TO SET - SAMPLING RATE
(while in the Surface Mode)
Factory set for 30 sec., the Sampling Rate can be set to
values of 2, 15, 30, or 60 sec., or 2, 5, 10 ft (.5, 1.5, 3 m).
Sampling Rate is the interval at which data samples are
recorded during a dive for subsequent download to the PC
program. This setting has no effect on displayed data or
data in the unit's Log.
• Press Both buttons, release when SET: 2 appears.
• Press and release the Advance (Front) button, the Units
screen appears with the set point flashing.
• Press the Advance (Front) button 13 more times.
• The graphic SR and SECS (or FEET) appear with the
Sampling Rate value flashing (Fig. 38).
• Press and release the Select (Side) button to advance
the Rate one selection at a time.
• Press the Advance (Front) button to accept the setting
and advance to Set Digital Gauge Mode, or press and
hold Both buttons for 2 seconds to revert to Surface
Mode.
Fig. 38 - Set Sampling Rate
To Next Page
Loading...
