80
Simulated Post Dive Surface Mode
• The Simulator will enter Demo Surface Mode (Fig. 82)
upon ascending to 3 feet (1 meter) or shallower.
• Press and hold the Select (Side) button for 4 seconds to
access Time Acceleration. The small time clock icon
begins flashing.
• Press and release the Select (Side) button to increase
Surface Interval Time 1 minute per real time second.
• Press and release the Select (Side) button during the
Time Acceleration to restore the normal time rate of 1
second per real second.
• Press and release the Advance (Front) button to access
FO2 Set Mode. The FO2 graphic and value previously
set will appear with the value flashing.
• Press and release the Select (Side) button to increase
the FO2 value in increments of 1%.
• Press and release the Advance (Front) button to accept
the setting and return to Demo Surface Mode.
• Press and hold the Select (Side) button for 2 seconds
to access Dive Mode for a repetitive dive. The DOWN
Arrow will appear flashing.
• Pressing and holding Both buttons simultaneously for 2
seconds will revert operation to real Surface Mode.
Fig. 82 - Demo Surface Mode
To Next Page
Loading...
