seemix seeport 2 - Page 33

33
Seeport 2 User Manual
Expansion Connectors
Two Seeport mixers can be connected and operated in a ’master/slave’ configuration. The 8 mixed outputs
from the one mixer (slave) are fed to the eight mix buses of the other (master). The connection is made via a
25-pin D-sub expansion cable. This allows, for example, two 8 channel mixers to be used as a 16 channel
mixer.
The cue signal buses in the two mixers are directly connected together.
The 0 volt references of each mixer are directly connected together.
Pin configuration of the multi-pin connectors and cable connections are shown below.
5. TECHNICAL INFORMATION
Insert Points Connectors
Insert points for inputs are connected on a 9-pin D-sub connector on the back panel above each module.
Pin-outs and views are shown below.