English-57
Environmental Information
This television is designed to consume less
energy to help save the environment. To
reduce energy consumption, you should
take the following steps:
You can use the Power Save Mode setting,
located in the Picture menu. If you set the
Power Save Mode as Eco, the TV will switch
to energy-saving mode and the luminance
level of TV set will be decreased to the opti-
mum level. Note that some picture settings
will be unavailable to be changed when the
TV is in Power Save Mode.
If Picture O is selected, “Screen will be o
in 15 seconds.” message will be displayed.
Select PROCEED and press OK to con-
tinue. The screen will be o immediately.
When the TV is not in use, please switch o
or disconnect the TV from the mains plug.
This will also reduce energy consumption.
Standby Notifications
1) If the TV does not receive any input signal
(e.g. from an aerial or HDMI source) for 5
minutes, the TV will go into standby. When
you next switch-on, the following message
will be displayed: “TV switched to stand-
by mode automatically because there
was no signal for a long time.” Press OK
to continue.
2) If the TV has been left on and not been
operated for a while, the TV will go into
standby. When you next switch-on, the
following message will be displayed. “TV
switched to stand-by mode automati-
cally because no operation was made for
a long time.” Press OK to continue.
Accessories Included
• Remote Control
• Batteries: 2 x AAA
• Instruction Book
• Wall Mount Kit (Optional)
TV Control Switch & Operation
The Control Stick allows you to control
the Volume / Programme / Source and
Standby-On functions of the TV.
To change volume: Increase the volume by
pushing the stick right. Decrease the volume
by pushing the stick left.
To change channel: Scroll through the
stored channels by pushing the stick up
or down.
To change source: Press the middle of
the stick, the source list will appear on the
screen. Scroll through the available sources
by pushing the stick up or down.
To turn the TV off: Press the centre of
the stick down towards the TV and hold
it down for a few seconds, the TV will turn
into standby mode.
Note: Main menu OSD cannot be dis-
played via control button.
JJ Getting Started
Notifications & Features & Accessories
To Next Page
Loading...
Need help?
General
