English-66
lation. Press OK button to continue.
Aerial Installation
If you select AERIAL option from the Search
Type screen, the television will search for digital
terrestrial TV broadcasts.
NOTE: You can press MENU button
to cancel.
After all the available stations are stored, the
Channel List will be displayed on the screen.
If you like how the channels are sorted ac-
cording to the LCN (*), please select “Yes”
and than press OK.
Press MENU button to quit channel list
and watch TV.
(*) LCN is the Logical Channel Number
system that organizes available broadcasts
in accordance with a recognizable channel
sequence (if available).
Cable Installation
If you select CABLE option and press OK
button on the remote control. To continue,
please select YES and press OK. To can-
cel operation, select NO and press OK.
You can select frequency ranges from this
screen.
Enter the frequency range manually by us-
ing the numeric button.
NOTE: Searching duration will change
depending on the selected search step.
Satellite Installation
If you select Satellite option from the
Search Type screen, you can set a satellite
and watch the satellite channels. When you
select Satellite installation, Antenna Type
menu will be displayed.
There are three types of antenna selection.
You can select Antenna type as Direct,
Unicable or DiSEqC switch by using “ ”
or “ ” buttons.
Direct: If you have a single receiver and a
direct satellite dish, select this antenna type.
After selecting Direct, another menu screen
will be displayed. Select an available satellite
and press OK to scan for services.
Unicable: If you have multiple receivers and
a unicable system, select this antenna type.
Press OK to continue. Configure settings
by following instructions on the screen.
Press OK to scan for services.
DiSEqC switch: If you have multiple sat-
ellite dishes and a DiSEqC switch, select
this antenna type. After selecting DiSEqC
switch, another menu screen will be dis-
played. You can set four DiSEqC options
(if available). Press GREEN button to scan
all satellites or press YELLOW button to
scan only the highlighted satellite. To save
and exit press OK button.
TKGS installation
After the antenna type is selected and other
satellite settings are made, press the Red
button to start TKGS Installation. You can
select to install HD or SD channels during
the installation. This selection can be done
later too using the Preferred List option
under the TKGS Installation menu. The
selection will be activated, after switching
the TV o and back on again or after a
manual update as described below.
If wanted TKGS Installation can be ap-
plied manually after the First Time Instal-
lation. Press the Menu button. Select
System>Settings and press OK. In the sub
menu highlight Satellite Settings and press
OK. Then select Antenna Installation.
Then follow the above mentioned steps to
start a TKGS Installation.
The second way to apply TKGS instal-
lation manually after the First Time
To Next Page
Loading...
