Sega KO DRIVE - System Test Mode

32
EXPLANATION OF TEST AND DATA DISPLAY
9
9-2 SYSTEM TEST MODE
■ SYSTEM TEST MODE Screen
1
Press the TEST Button after powering on the unit to display the following SYSTEM TEST MODE.
2
Use the SERVICE Button to move the cursor to the desired test item.
3
Press the TEST Button to enter the selected item’s test.
4
After the test is complete, move the cursor to EXIT and press the TEST Button to return to the game
play screen.
For a detailed explination on the SYSTEM TEST MENU, please refer to chaper 16 - Game Board.
The details of changes to Test Mode settings are saved when you exit from each
Test Mode by selecting EXIT. Be careful because if the power is turned off before
that point, changes to the settings will be lost.
SYSTEM TEST MODE can be used to check the information or the operation of RINGWIDE, adjust Monitor
color, and perform coin/credit settings.
SYSTEM TEST MODE
GAME TEST MODE ...........................9-3
SYSTEM INFORMATION ....................9-4
STORAGE INFORMATION ................9-5
JVS TEST ............................................9-6
MONITOR TEST .................................9-7
SPEAKER TEST ...................................9-8
COIN ASSIGNMENTS .......................9-9
CLOCK SETTING ..............................9-10
NETWORK SETTING ......................... 9-11
-> EXIT ....................................................9-12
SELECT WITH SERVICE BUTTON
AND PRESS TEST BUTTON