When charging, hydrogen produced by the 12V battery is highly
explosive gas. Please follow these
precautions when charging:
If charging the 12V battery still installed in the vehicle, be sure to
disconnect the ground cable.
Make sure the power switch on the charger is off when connecting
and
disconnecting the charger clamps to the 12V battery.
Only charge slowly (5A or less). If charge quickly, the 12V battery
may
explode.
BATTERY
CHARGING
Read all instructions before the installation and charging this battery.
The battery is already filled with electrolyte in factory. Never pry the
battery caps off or add any fluid to this battery.
The most important thing when maintaining the battery is to keep it fully
charged.
When using an automatic charger, refer to the charger manufacturer's
instructions for recharging. After charging, apply Dielectric Grease to the
terminal bolts and terminals.
Recommended battery charger:
For battery charging use Shark CN-4000 or CI-4000 automatic charger.
To Next Page
Loading...
Need help?
General
