CLUTCH / BELT BREAK-IN
Proper run-in of the clutch and driving belt will ensure longer
service life and better performance. Run the run-in clutch and belt
at low speeds for the recommended run-in time by only pulling
light loads. Avoid violent acceleration and high speed running
during run-in period. If the belt is broken, be sure to clean up the
intake and outlet pipeline and any debris from the clutch and
engine compartment during belt replacement.
NEW OPERATOR DRIVING PROCEDURES
1.
Wear protective riding gear. See the Safe Riding Gear section.
2.
Perform the pre-ride inspection.
3.
Place the transmission in Parking gear.
4.
Mount the vehicle from the left side.
5.
Sit upright with both feet on the footrests and both hands on
the handlebars.
6.
Start the engine to warm up.
7.
Ride slowly. Practice maneuver and use the throttle and
brakes on level surfaces.
STARTING THE VEHICLE
1.
Turn the ignition switch key to the "ON" position.
2.
Step forcefully on the foot brake or press forcefully the
brake lever, and place the transmission in neutral "N” gear.
3.
Move the engine start/stop switch to the " " position, then
release it to start the engine.
4.
The engine is started. Step forcefully on the foot brake
and place
the transmission to required gear.
To Next Page
Loading...
Need help?
General
