112
MAINTENANCE,STORAGE AND TRANSPORTATION
Oil drain position 2
The oil drain position 2 is located inside the left cover assembly.
Remove the flange bolt M6×16 and step bolts on the left cover
assembly first, then remove the left cover assembly, and the oil
drain position 2 can be seen.
1. Put the vehicle on the horizontal surface.
2. Start the engine. Let it heat up for two to three minutes at idle.
!
WARNING
Hot oil can cause skin burns. Don't let hot oil touch the skin
3. Place a suitable container under the oil drain plug
1
to
collect the discharged waste oil
4. Remove the oil drain plug
1
, remove the O-ring and wait for
the waste oil to drain completely
5. Place a suitable container under the oil drain plug
3
to
collect the discharged waste oil
6. Remove the oil drain plug
3
and remove the O-ring
4
7. Take out the oil filter strainer 5 and clean the oil filter. See
P114 for details
8. Wait for the waste oil in drain position 1 and drain position 2 to
drain completely
Torque
Drain Plug: 11.8-14.8ft·lb. (16~20N.m)
To Next Page
Loading...
