135
MAINTENANCE,STORAGE AND TRANSPORTATION
SHOCK ABSORBER ADJUSTMENT
The spring adjustment sleeve of the hydraulic shock absorber
there are 5 adjustment positions, the spring can be adjusted
according to different terrain and loading conditions, if you feel
too soft and too hard, it can be adjusted by the spring table
adjustment.
Position
1
:
Standard position.
Position
2
~
5
:
When vehicle load is heavy, it can be adjusted to this position.
Use crescent wrench
6
to adjust the impact spring pressure.
!
CAUTION
When adjusting the shock absorption position, always adjust the left
and right shock absorption to the same position. Step up or down
one position at a time during adjustment. Do not try to make large
adjustments, which may damage the shock absorber.
To Next Page
Loading...
