89
OPERATION
to be rolled on one end of the barrel and may damage the
rope or winch.
• Note that the rope-drawing capacity of the winch is the
maximum rope- drawing capacity of the first layer, do not
operate the winch with overload capacity past this amount of
rope.
• Never hook the rope back to itself, otherwise the rope will
become damaged. Use trunk protection protector.
• Before operation, make sure that the winch is firmly installed
on the vehicle or bracket.
• Before moving heavy objects, check the rope to prevent kinks
and uneven wire layers. The rope slack must be properly
tightened under a weight of about 220 lbs. (100Kg).
• When pulling the load, be sure to place a protective layer
on the wire rope near the hook end. This will prevent the
possibility of breaking the rope and help prevent serious
injuries and damage.
• Do not move the winch to assist in hauling heavy objects, it is
easy to overload the winch and cause damage to the rope.
• Pay attention to the dangerous area. Stay away from the
danger area during winch operation.The dangerous area is
the area that contains the winch drum, fairlead, rope, pulley
block, hook and motor.
• When the winch is under load, do not approach or cross the
To Next Page
Loading...
