Segway i2 SE - Fenders

5–1
Segway Personal Transporter SE Service Manual
5 Fenders
This chapter describes the removal and installation procedures for the fenders
on a Segway PT. The fenders on the Segway PT are designed to protect the rider
from debris and to safeguard the rider while leaning into turns.
There are two fenders per Segway PT.
The i2 SE has one type of fender. The x2 SE and x2 SE Turf has another type of
fender that attaches to a fender frame.
WARNING!
• Failure to follow these safety precautions could lead to electrical shock,
serious injury, death, or damage to property.
• Read all instructions.
• Power off the Segway PT.
• Unplug the Segway PT.
When to Replace
You need to replace a fender for reasons that include, but are not limited to, if it
is cracked or otherwise broken.
Applies to Models
i2 SE, x2 SE, x2 SE Turf
Qualications
Customer Replaceable
Customer Replaceable Kits
i2 Fender Kit (20945-00001)
1 i2 Fender
4 Fender Fasteners
x2 Fender Kit (left side) (20961-00001)
1 x2 Fender
4 Fender Fasteners
x2 Fender Kit (right side) (20962-00001)
1 x2 Fender
4 Fender Fasteners
x2 Fender Frame Kit (23682-00001)
1 x2 Fender Frame
3 Fender Frame Fasteners
4 Fender Fasteners