Segway i2 SE - i2 SE Fender

Segway Personal Transporter SE Service Manual
5–2
Fenders
i2 SE Fender
Removal
Tool Required: T-20 6-lobe wrench
1. Make sure the PT is powered off and unplugged.
2. Remove the Tire/Wheel Assembly (page 4–2).
3. Using a T-20 6-lobe wrench, remove the four
fasteners holding the Fender to the gearbox. See
Figure 5–1.
4. Lift the Fender off the gearbox.
Installation
Tools Required: T-20 6-lobe wrench
Torque wrench
1. Make sure the PT is powered off and unplugged.
2. Orient and place the Fender on the gearbox. See
Figure 5–1.
3. Using a T-20 6-lobe wrench, install the four
fasteners. Torque to 1.5 N-m (13 in-lbf).
4. Install the Tire/Wheel Assembly (page 4–2).
5. Perform post-service tests (page A–1).
Figure 5–1: i2 SE Fender
i2 Fender
20538-00001
1.5 N-m (13 in-lbf)