Seiko Astron SSJ009J - Managing In-flight Mode; Setting In-flight Mode; Resetting In-flight Mode

In-flight mode ( )
Set to the in-flight mode ( ) where the
reception may influence operation of other
electronics devices in an airplane, etc.
In the in-flight mode ( ), the GPS signal
reception (time zone adjustment, manual
time adjustment, and automatic time
adjustment) does not work.
< In-flight mode ( ) >
The mode is displayed when the crown is
pulled out to the first click.
012
Set to the in-flight mode ( ).
1
Pull out the crown to the first click
The seconds hand will move, and the currently set in-
flight mode status (42-second) / reset (0-second) will
be displayed.
012
Pull out
to the
first click
* Take note that turning the crown at this time will
perform manual time difference setting.
2
Continue to press Button B
(3 seconds)
The seconds hand will move to the
(42-second)
position.
012
Press for
3 seconds
3
Push the crown back in
012
Push
back in
→ Setting the destination time zone while in flight, etc.
(manual time difference setting),
and setting/resetting DST (daylight saving time or
“summer time”) P. 23
Reset the in-flight mode ( ).
Turn off the in-flight mode when leaving an
airplane, etc.
If it is not turned off, the watch will not be able to
receive GPS signals.
Carry out operation A to C.
In
operation B, when the seconds hand points to
the 0-second position, in-flight mode (
) is
reset.
* In operation B, the seconds hand shows a
“0-second position” and you can see that
the in-flight mode ( ) has been canceled.
When boarding (in-flight mode ( ))
25
4
BASIC OPERATION (HOW TO SET THE TIME/HOW TO RECEIVE GPS SIGNALS, ETC.)
ASTRON 3X22 GPS SOLAR