29
4. When the printer enters the Setting Mode, a message for selecting MS to be set is printed as
shown in Figure 11-2.
Press the FEED Switch the number of times corresponding to the selected MS number, and then
press the POWER Switch.
・When pressing the FEED Switch once, "1 : MS1 Setting" is selected.
・When pressing the POWER Switch without pressing the FEED Switch, "0 : Exit" is selected.
Figure 11-2 MS Selection Message
5. A message for selecting the functions assigned to the selected MS is printed as a sample shown in
Figure 11-3.
Press the FEED Switch the number of times corresponding to the selected function number, and
then press the POWER Switch.
・When pressing the FEED Switch once, "1 : Interface" is selected.
・When pressing the POWER Switch without pressing the FEED Switch, "0 : Return to MS Selection" is
selected.
Figure 11-3 Function Selection Message
(Example: Selected MS1 Setting)
[MS Selection]
0 : Exit
1 : MS1 Setting
2 : MS3 Setting
3 : MS4 Setting
4 : MS5 Setting
5 : MS7,8 Setting
6 : Wireless Setting
7 : USB Setting
8 : International Character
9 : Character Code Table
10: MS Default Setting
Press the FEED switch an equal
number of times to the selected
number. After that, press the
POWER switch.
[MS1 Setting]
0 : Return to MS selection
1 : Interface
Press the FEED switch an equal
number of times to the selected
number. After that, press the
POWER switch.
To Next Page
Loading...
Need help?
General
