30
6. A message for selecting the setting value of the selected function is printed as a sample shown in
Figure 11-4.
Press the FEED Switch the number of times corresponding to the selected setting value number,
and then press the POWER Switch.
・When pressing the FEED Switch twice, "2 : Wireless" is selected.
Figure 11-4 Setting Value Selection Message
(Example: Selected Interface)
7. A message for confirming the selected setting value is printed as a sample shown in Figure 11-5.
Figure 11-5 Setting Value Confirmation Message
(Example: Selected Wireless)
To save the setting value to the memory, press the FEED Switch. Figure 11-2 MS Selection
Message is printed.
To discard the selected item, press the POWER Switch. Function Selection Message is printed as a
sample shown in Figure 11-3. If select "0 : Return to MS Selection", function selection is not
performed, and Figure 11-2 MS Selection Message is printed. (Press the POWER Switch without
pressing the FEED Switch.)
To continue to set functions, return to 4.
8. To exit the Setting Mode, select "0 : Exit" in Figure 11-2 MS Selection Message. (Press the
POWER Switch without pressing the FEED Switch.)
The test print and Figure 11-1 Mode Selection Message printing start again. Verify that the
functions are properly set.
To return to the print-ready status, select "0 : Normal Mode" in Mode Selection Message. (Press the
POWER Switch without pressing the FEED Switch.)
To set functions again, return to 3.
[Interface]
0 : Return to function selection
1 : USB
2 : Wireless
Press the FEED switch an equal
number of times to the selected
number. After that, press the
POWER switch.
[Interface]
Set “Wireless” ?
Save : FEED Switch
Discard : POWER Switch
To Next Page
Loading...
Need help?
General
