Sekonic L-508 CINE ZOOM MASTER - SETTING DIP SWITCHES; SELECTING SHUTTER ANGLES

L-508 Cine BASIC OPERATION (Additional operation to L-508)
Still mode
When the Still mode is selected, the same measuring modes available on
L508 can be selected.
To select each mode, turn the Set/change dial while hold down the MODE
button. Please refer to the L-508 instructions “Setting Measuring Mode” for
further instructions.
2. Setting DIP switches (Cine/Still mode)
Special features are selected with the DIP switches inside the battery
compartment. You can customize the L-508Cine by activating desired functions.
DIP switch assignment
DIP switch Descriptions when the DIP switches are "ON" positions. Factory
settings
1 TIME0.5 Setting half shutter speed OFF
2 F No./EV Selecting F/stop priority measurement and EV readout.
F/stop priority measurement is effective only in Still mode.
OFF
3 MULTI Selecting Multiple flash function.
Multiple flash function is effective only in Still mode.
OFF
4 CINE Selecting CINE mode. ON
STILL Selecting Still mode. OFF
3. Selecting Shutter Angles (Cine mode)
2. Turn the Set/change dial to obtain desired shutter
angle. You can select a shutter angle from 5° to
270° in 5° step. In this example, 90° is selected.
-3-