2. Setting DIP switches (Cine/Still mode) / 3. Selecting Shutter Angles (Cine mode)
4. Setting Cine Speeds (Cine/Still mode) / 5. Filter Compensation (Cine/Still mode)
Note:
Shutter angle settings can be changed only when a cine speed is displayed.
4. Setting Cine Speeds (Cine/Still mode)
1. Turn the Set/change dial to select the desired cine speed. Cine speeds
are displayed after 1/8000, 1/200, 1/400 and the unit is in frames per
second (f/s.) . The following cine speeds will be displayed:
1, 2, 3, 4, 6, 8, 12, 16, 18, 24, 25, 30, 32, 36, 40, 48, 50, 60, 64, 72, 75,
90, 96, 100, 120, 125, 128, 150, 200, 240, 250, 256, 300, 360, 375, 500,
625, 750, 1,000 frames per second.
5. Filter Compensation (Cine/Still mode)
1. Hold the IS02 button and turn the Set/change dial to select the symbol
representing the desired filter number.
2. The seven different symbols for
filter numbers are displayed after
IS08000. The symbol and the filter
compensated readout are
displayed while holding down the
ISO2 button. The example
drawings right are “85-“ or “n9-“
symbol is selected.
See the Filter Conversion table below.
Symbols on
LCD
85- n3- n6- n9- A3- A6- A9-
Filter No. 85 ND3 ND6 ND9 85ND3 85ND6 85ND9
Exposure
Compensation
-0.7
(-2/3)
-1 -2 -3 -1.7
(-1 2/3)
-2,7
(-2 2/3)
-3.7
(-3 2/3 )
To Next Page
Loading...
