7. Flash Measurement with cord
7.1 Single flash measurement
(II
Flash measurement with cord
(Flash measurement with cord)
e mode selection button
(e(Q)*
-
0 Never use the L-408 in flash mode when your hands are wet in
conditions such as rain, splashing water or wet place. High voltage
at the synchro terminal may result in an electric shock. Use the
synchro terminal cap and select the flash without cord mode for
safety.
*
The flash unit may “pop” when you connect the synchro cord to the
L-
408 terminal or when you operate the POWER switch.
1
*
When using a flash bulb, check the synchro speed of the camera you
use. Measurement with a flash bulb cannot be made in the flash
cordless mode.
F/EV/MULTI button
(e@).
@ Shutter speed setup
Set the desired shutter speed using the UP/DOWN
Single flash measurement
Select the single flash measurement mode using the
button
(e@).
Synchro cord connection
Plug the flash synchro cord into the L-408 synchro
terminal.
NoTE
@ Measurement
Press the measuring switch
(=a).
The flash will fire and the correct aperture will
appear on the LCD panel.
I
8.1.8.8.848.8*
1
14 2
2.8
4 56
8 11
1622324564 30
14
To Next Page
Loading...
Need help?
General
