--_l
NOTE
l In this mode, you can set the shutter speed from 1 sec to 1/500 sec.
After 1/500 sec., 1/75, 1/80, 1/90, 1/100, 1/200 and 1/400 sec. appear in
the display and you can select a particular shutter speed.
_
--_
-._
/
@ Measurement
Press the measuring switch
(=@).
The flash will fire, and the aperture will
appear on the LCD panel. Also! the cumulative aperture of each measurement
and the number of accumulated flashes also appear.
When a single flash firing is
measured
When four flash firings are
measured
:
ra
IT
ii
j-j-
j
/J$:‘- re
5
I~l*l*l.l*I*l*l.~*
1
14 2
28 4 E6
8
111622324564 90
@ To cancel the Cumulative mode, just press the F/EV/MULTI button, To restart
metering with new setup, press the F/EV/MULTI button.
NOTES
e When the IS0 setup is changed, the measurement data is recalculated
and redisplayed.
*
If the shutter speed is changed after measurement, the measurement is
lost and both the number of accumulated flashes and aperture are
cleared to zero (0).
7.4 Contrast measurement
The contrast measurement is the same as for ambient light measurement (see 6.6 of
Page 13).
16
To Next Page
Loading...
Need help?
General
