NOTES e When the measuring range is exceeded, “Eu” (underexposure) or “Eo”
(overexposure) appears. Correct the shutter speed or the light source.
@
If a rapid start luminescent lamp or special illumination lamp is to be
measured (although no flash fires), connect the synchro cord and use
the flash measurement with cord.
8.2 Data memory
In the single flash measurement mode, up to three measurements can be stored in
memory. Memory storage is the same as for ambient light measurement (see 6.5 of
Page 12).
8.3 Cumulative measurement
(i’
/
Flash measurement without cord
Select the (Flash measurement without cord)
mode using the mode selection button
(+a).
@ Cumulative measurement
Select the flash cumulative measurement mode
using the F/EV/MULTI button
(&)).
@ Shutter speed setup
Set the desired shutter speed using the UP/DOWN
button
(&)).
+ In this mode, you can set the shutter
speed from 1 sec to 1/500 sec. After 1/
NOTE
,
,)
)
)
)
500 sec 1/75, 1/80, 1/90, 1/100, 1/200
and 1/400 sec. appear in the display and
you can select a particular shutter speed.
@ Measurement
a-
imom
I’;2
Press the measuring switch. The
mark
/
I
\’
I
continues blinking and your L-408 enters the
i
Ia
:f
,
i
174
w
--
ICJ
standby mode.
1 1.4 2 2.8 4
Ei
5
11162232C64
30
~_
18
To Next Page
Loading...
Need help?
General
