8. Flash Measurement without cord
8.1 Single flash metering
<jr!
Flash measurement without cord
(Flash measurement without cord) mode using the mode selection
button.
@I
Single flash measurement
Select the single flash measurement mode using the F/EV/MULTI button.
(3
Shutter speed setup
Set the desired shutter speed using the UP/DOWN button.
NOTE
+ In this mode, you can set the shutter speed from 1 sec to 1/500 sec.
After 1/500 sec., 1/75, 1/80, 1/90, 1/100, 1/200 and 1/400 sec. appear in
the display and you can select a particular shutter speed.
Cj>
Measurement
Press the measuring switch. The mark will
appear and your L-408 is ready to measure
(Standby mode)
.
When the flash fires, your L-408 displays the
correct exposure.
NOTES
*
After this measurement, the
remains in standby mode.
mark continues to blink and your L-408
0 The standby mode continues for approximately 90 seconds and you can
measure again within this time. If the mark goes out after 90 seconds
press the measuring switch again.
*
When you change the film speed, the measurement is recalculated and
a new correct value is displayed.
l If the flash is NOT metered by your L-408 (when the flash is dimmer
than the ambient light), use flash measurement with cord.
@
If the shutter speed is changed after measurement, the measurement is
lost and the aperture is cleared to zero (0).
To Next Page
Loading...
