When the flash fires, the aperture value will appear on the LCD panel. The
cumulative exposure of each measurement and the number of flashes also
appear.
When a single flash firing is
measured
b‘
0
rj
ii
,-,-
’
j
iJ/J$‘-
d
c
3
/,
,.e..r,.l*.*l.
1 1.4 2 2.8 4 5.6 8 11 162?324564d
When four flash firings are measured
(
*.,.,*,.,..*..,.,*
1 1.4 2 2.8 4 5.6 8 11 16 22 32 45 64 90
~3 To cancel Cumulative mode, just press the FEV/MULTI button. To restart
metering with new setup, press the F/EV/MULTI button.
NOTES
@
After this measurement, the
remains in standby mode.
mark continues to blink and your L-408
0
The standby mode continues for approximately 90 seconds.
8 If the flash is NOT metered by your L-408 (when the flash is dimmer
than the ambient light), use flash measurement with cord.
*
If the shutter speed is changed after measurement, the measurement is
lost and the exposure is cleared to zero (0).
l If a rapid start luminescent lamp or special illumination lamp light is to
be measured (although no flash fires), use flash measurement with
cord.
*
No flash bulb measurement is supported. Use the synchro cord
instead.
8.4 Contrast measurement
Contrast measurement is the same as for ambient light measurement (see Step 6.6 of
Page 13).
19
To Next Page
Loading...
Need help?
General
