Sekonic ST-50A - Initializing the SD Card

- 19 -
CAUTION
・The SD card initialization screen will not be displayed if
the SD card is not inserted, if the [SD Card Write] switch
is set to ON, or write-protect tab on the SD card is set to
ON,or the battery level indicator is flashing.
・During initialization of the SD card, do not remove the
SD card or turn this instrument OFF. This could damage
the SD card.
・For some SD card types and sizes, initialization can take
an extended time. This is not a malfunction.
・The initialization process deletes all the data files on the
SD card. To delete a portion of the data files only, use a
PC to delete the files.
・When initializing the SD card , usage of new batteries or
an AC adapter is recommended.
5-6. Initializing the SD Card
The initialization process deletes all the data files on the SD
card.
①
If the
【
SD Card Write
】
switch is set to ON, set it to OFF.
②
Pressing the
【
FUNCTION
】
key five times in the normal
measurement screen shows
【
MODE
】
,
【
MEMORY
】
, and
【
CLEAR
】
.
③
Press the
【
ENTER
】
key to change the
【
CLEAR
】
indica-
tor from fully lit to blinking.
④
Pressing the
【
ENTER
】
key and the
【▼】
key at the same
time changes the
【
MEMORY
】
indicator from fully lit to
blinking and starts initialization of the SD card.
⑤
When initialization
of the SD card is completed, the blink-
ing changes to fully lit, and "End" is displayed.
⑥
To return to the normal measurement screen, press the
【
FUNCTION
】
key.
Reference
・
The display returns to the measurement screen if no
operation is performed within one minute. This does
not apply when initialization of the SD card is in prog
-
ress.