Need help?Do you have a question about the Selco Genesis 245 TLH and is the answer not in the manual?
Declaration of compliance with CE directives and standards.
Explains safety and operational symbols used in the manual.
Guidelines for protecting users and bystanders from welding hazards.
Advice on ventilation and respiratory protection during welding.
Precautions to prevent fires and explosions in the work area.
Information on meeting EMC standards and minimizing interference.
Instructions for connecting the welding unit to the power supply.
Guidelines for positioning and managing welding cables.
Importance of earthing for safety and preventing interference.
Recommendations for earthing the workpiece to reduce emissions.
Methods to reduce electromagnetic interference using shielding.
Specifies the casing's protection against solids and liquids.
Identifies machine risks and solutions to prevent them.
Safe methods for moving and handling the welding equipment.
Rules for placing the welding unit for optimal operation.
Safety guidelines for storing compressed gas cylinders.
General instructions for setting up the welding machine.
Details on connecting the unit to the power supply, including cable specs.
Instructions for proper electrical earthing of the system.
Lists common electrical faults and their causes.
Steps for initial setup and operation of the welding system.
Procedures for powering on and initial setup.
Troubleshooting guide for MMA welding issues.
Troubleshooting guide for TIG welding issues.
Information on optional remote control devices.
Details on the RC16 remote control.
Details on the RC12 pedal remote control.
Routine maintenance procedures for the power source.
Overview of the Genesis 245 TLH welding capabilities.
Description and function of the front panel controls and indicators.
Overview of panel controls, selection keys, and parameter adjustment.
Detailed settings for TIG welding like slope-up, peak time, base time, frequency, and current settings.
Procedure for setting and adjusting additional parameters, including pre-gas, hot start, arc force, and external limits.
List and explanation of error codes displayed by the machine.
Explains principles of welding with coated electrodes, including preparation and technique.
Overview of the TIG welding process and its principles.
Explanation of DCSP and DCRP in TIG welding.
Explanation of pulsed DCSP for enhanced weld control.
Guidelines for TIG welding steel, copper, and using protective gas.
Details on voltage, power, current, adjustment range, and output voltage.
Machine's protection rating, insulation class, dimensions, and weight.
General| Input Voltage | 230 V |
|---|---|
| Input Current | 16 A |
| Output Current Range | 5 - 240 A |
| Open Circuit Voltage | 70V |
| Protection Class | IP23 |
| Insulation Class | H |
| Welding Processes | TIG, MMA |
To Next Page