4
2. Product information
SELF TACKING JIB SYSTEMS
A self-tacking jib makes life on board a lot easier, particularly for short-handed crews. The jib sheet is led
to a car which moves to leeward during the tack with no need to touch the sheet. Tacking is as simple as
steering the boat through the wind.
System 22 is designed as a universal retro-t self-tacking system for sail boats ranging from approximately
25 to 35 feet. The length of the legs can be cut to the correct length and the angle of the track and deck
ttings are adjustable. The track is available from stock in two standard radiuses to give a good alignment
of the sheet load to the car and track. Simply, the system ts to most boats, but exceptions will naturally
occur and should be considered prior the purchase.
Obstacles can be objects such as a hatch or a ventilator tted just forward of the mast or the
construction of the deck which must be solid as opposed to a sandwich construction.
Track, car, consoles, deck ttings and blocks for the sheet arrangement makes for a complete system.
The sail must be designed for a self-tacking system and cannot overlap the mast. The routing of the sheet
must also be planned for in advance. Customized tracks, single curved or double curved can be ordered
by submitting necessary measurements, see enquiry form 595-952-E, available at www.seldenmast.com.
End stops with rubber shock absorbers.
Centre consoles
Car
Side console
Block
Curved track
Foot
To Next Page
Loading...