18
6. Service and maintenance
6.1 Frequent maintenance
Cleaning
Rinse the self-tacking system with fresh water regularly to get rid of salt and dirt.
A mild detergent can be used to help get dirt o.
Pay extra attention to the ball bearings inside the car. Rinse the car thoroughly with fresh water
while moving it back and forth on the track.
Make sure the track is clean and free from damage that might cause the car to malfunction.
Pay extra attention to the ball race where the ball bearings run. Wipe with cloth to ensure the
surface is clean.
Lubrication
Seldén high performance Lubricant can be used to lubricate the car.
Art. No. 312-534
6.2 Annual maintenance
Check that all screws are tight.
• Open the lid on the side console and check so the nuts are tight
• Check the hex screw for the joint bracket
• Check the two screws on the back of the centre bracket
The self-tacking system and yacht are at risk of damage if fasteners are not completely
tightened during assembly. Improper tightening of fasteners can result in assembly failure
and potential for personal injury.
To Next Page
Loading...