ATSEL HMI User Manual
3.After adding, click close button exit, after downloading the configuration you can do
data exchange according to the set transmission type.
Alarm
Function Introduction
When triggering some events that should not be triggered during the operation of the
device, the system will make warning and record the time and content of the
corresponding events. The alarm is used to set the alarm information. Only the alarm is
configured, the alarm control and the dynamic alarm bar can be used normally.
1. Set the alarm information, firstly set the trigger condition
2. Record the real-time alarm: to show the real-time alarm data, alarm
scrollbar
3. System alarm setting: to set the display mode of overall pages alarm.
To Next Page
Loading...