SELFSAT SNIPE DRIVE User Manual

6
B. Stationary mode (Option)
For example :
a.
b.
c.
d.
e.
f.
Ensure that the unit is turned o
Press and hold MODE button, and turn on the power switch
All satellites LEDs light on while booting the system (15~30 seconds)
The last status satellite is automatically selected to start searching
(Tracking LED is o as stationary mode does not require tracking)
When Lock LED becomes solid this means the satellite is found
If the other satellite is desired, move to the correct satellite and press SET to
conrm the new satellite
Mode LED is ON if stationary mode is selected
1
2
3
LNB 1
LNB 2
LNB 3
Astra 2
Astra 1
Hotbird
NO LNB Satellite
C. DiSEqC 1.1 setting
Set-Top-Box power detection for DiSEqC is always on but works when
stationary mode is selected.
Refer SNIPE DRIVE’s pre-set satellites for DiSEqC when user setup at STB.
D. Sleep mode
a.
b.
For automatic sleep mode, when the vehicle keeps stationary status for
more than 1 minute, it is changed to sleep mode
For manual sleep mode, when Mode button is pressed for about 5 seconds,
the LED which points the receiving satellite shows sleep mode by switching
on and o LED

SELFSAT SNIPE DRIVE Specifications

General

Brand	SELFSAT
Model	SNIPE DRIVE
Category	Antenna
Language	English