SEM 2SSD - Page 13

13
508.366.1488 | www.semshred.com
Accessing Stage 2 Cutting Chamber:
1. Disconnect all power to the unit using proper lockout-tag out procedures (LOTO).
2. Open front door.
3. Remove the two painted side bolts holding the cutting chamber drawer in place (see figure 3).
4. Note: Never operate the machine without the bolts in place.
Requires 3/4” socket wrench (see figures 4 & 5).
Figure 3
Figure 4
Figure 5
Be sure that foam
blocks are
removed before
operating