13
Maintenance
• Clean the charger by wiping it with a dry or slightly damp cloth.
• Do not exert too much pressure on the charger during cleaning.
• Do not open the device to clean it.
• Do not use a vacuum cleaner.
Updating Charger Firmware
Updated rmware may be made available to add additional features or correct reported issues. The mobile app
can be used to check for new rmware and apply it to the charger.
Removing the Charger from your Account
If you no longer wish to access the charger from the mobile application, it can be deleted in the settings
section of the mobile application.
Factory Reset
To remove your account information from the charger, perform a factory reset:
• Delete the charger from your mobile application in the settings section of the charger.
• Use the supplied Allen wrench to press the recessed button in the small opening where the vehicle connector
attaches to the charger and hold it down for 15 seconds before releasing. Allow 3 minutes for the process
to complete.
To Next Page
Loading...
