SemaConnect 4 EV Series - Safety and Compliance

2
1. Safety and Compliance
This document provides instructions to install the SemaConnect charger and should not be used for any other
product. This product must be installed in accordance with the National Electrical Code (NEC), the Canadian
Electrical Code (CEC), or any applicable local code.
Review this manual and consult a licensed contractor and/or electrician before installation to ensure compliance with
local building practices, climate conditions, safety standards, and state and local codes.
There are 2 options for installation:
Option 1: Use the NEMA plug included with the charger
Option 2: Hardwired charger should be installed by a licensed contractor/ electrician and inspected by a qualied
installer prior to initial use. Under no circumstances will compliance with the information in this manual relieve the user
of responsibility to comply with all applicable codes and safety standards.
This document describes the most common installation and mounting methods. Contact SemaConnect where
it is not possible to perform an installation using the procedures provided in this document.
SemaConnect is not responsible for damages that may occur or result from installations that are not described in this
document. Please read and understand instructions before attempting to unpack, install, operate, or maintain this
equipment. Study the charger and its mechanism carefully before attempting to operate it on an energized circuit. All
possible contingencies that may arise during installation, operation, or maintenance, and all details and variations of this
equipment do not purport to be covered by these instructions. If further information is desired by the purchaser regarding
a particular installation, operation, or maintenance of particular equipment, contact SemaConnect.
General
The SemaConnect charger is grounded through a dedicated conductor to the ground connection at the
power distribution panel.
Statements
Reasonable effort has been made to ensure that the specications and other information in this manual are
accurate and complete at the time of publication. However, specications and other information in this manual are
subject to change at any time without prior notice. Use of the SemaConnect charger in a manner not intended or any
modication not approved by the manufacturer will void the limited warranty. Other than the limited warranty
,
SemaConnect products are provided “AS IS,” and SemaConnect and its distributors expressly disclaim all implied
warranties, including any warranty of design, merchantability, and tness for a particular purposes and
non-infringement, to the maximum extent permitted by law.
IN NO EVENT SHALL SEMACONNECT, INC. OR ITS AUTHORIZED DISTRIBUTORS BE LIABLE FOR ANY
INDIRECT, INCIDENTAL, SPECIAL, PUNITIVE, OR CONSEQUENTIAL DAMAGES, INCLUDING WITHOUT
LIMITATION, LOST PROFITS, LOST DATA, LOSS OF USE, COST OF COVER, OR LOSS OR DAMAGE TO
THE SEMACONNECT™ CHARGER ARISING OUT OF OR RELATING TO THE USE OR INABILITY TO USE
THIS MANUAL, EVEN IF SEMACONNECT, INC. OR ITS AUTHORIZED DISTRIBUTORS HAVE BEEN ADVISED OF
THE POSSIBILITY OF SUCH DAMAGES.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a residential environment. The equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
For questions, please contact SemaConnect:
Email: support@semaconnect.com
Phone: 1-877-794-2214 Ext: 105
Copyright ©2021 SemaConnect, Inc. All rights reserved.