1.1. Safety and Compliance
This document provides instructions to install the Series 7 and Series 7 Plus Charging Stations and should
not be used for any other products. This product must be installed in accordance with the National Electrical
Code (NEC), the Canadian Electrical Code (CEC) or any applicable local code.
Review this manual and consult a licensed contractor and/or electrician before installation to ensure
compliance with local building practices, climate conditions, safety standards, and state and local codes.
The Series 7/Series 7 Plus Charging Station should be installed by a licensed contractor/ electrician and
inspected by a qualified installer prior to initial use. Under no circumstances will compliance with the
information in this manual relieve the user of responsibility to comply with all applicable codes and safety
standards.
This document describes the most common installation and mounting methods. Contact SemaConnect Inc.
where it is not possible to perform an installation using the procedures provided in this document.
SemaConnect Inc. is not responsible for damages that may occur or result from installations that are not
described in this document.
Note: Make sure to TURN OFF the breakers before doing any electrical work!
General
The Series 7/Series 7 Plus Charging Station is grounded through a dedicated conductor to the ground
connection at the power distribution panel.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. The equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference at their own expense.
Statements
Reasonable effort has been made to ensure that the specifications and other information in this manual are
accurate and complete at the time publication. However, specifications and other information in this manual
are subject to change at any time without prior notice.
Use of the Series 7/Series 7 Plus Charging Station in a manner not intended or any modification not
approved by the manufacturer will void the limited warranty. Other than the limited product warranty
provided by SemaConnect, this manual and the SemaConnect Inc. products are provided “AS IS,” and
Installation Manuals Series 7 / 7 Plus EV Charging Station - 1
Copyright ©2021 SemaConnect, Inc. All rights reserved. Page 2 of 26
To Next Page
Loading...
