Sena 20S EVO - 20 S EVO CONFIGURATION SETTING

48
20S EVO
21 20S EVO CONFIGURATION SETTING
You can set the conguration of the 20S EVO by the voice menu
instruction as below.
1. To enter into voice conguration menu, press and hold the Jog
Dial for 12 seconds until the LED shows solid blue and you hear
high tone double beeps. You will also hear a voice prompt saying
“Conguration menu”.
2. Rotate the Jog Dial clockwise or counter-clockwise to navigate
between the menus. You will hear voice prompts for each menu
item as below.
3. You can enable the feature or execute the command by tapping
the Phone Button, or disable the feature by tapping the Jog Dial.
4. If any button is not pressed within 10 seconds, the 20S EVO will
exit the conguration and go back to stand-by.
5. If you want to exit the conguration immediately, rotate the Jog
Dial until you hear a voice prompt saying “Exit conguration”,
and tap the Phone Button.
The voice prompt for each menu item is as below:
(1) Speed dial
(2) Audio multitasking
(3) Intercom-audio overlay
sensitivity
(4) Navigation app support
(5) Audio boost
(6) Smart volume control
(7) Motion sensor sensitivity
(8) VOX phone
(9) HD intercom
(10) Eight-way intercom
(11) Voice prompt
(12) FM station guide
(13) Sidetone
(14) Noise control
(15) Delete all pairings
(16) Remote control pairing
(17) Universal intercom pairing
(18) Exit conguration