Sena 20S EVO - Setting Motion Sensor Sensitivity; Enabling;Disabling Voice Activated Phone Answering

52
20S EVO
21.7 Setting Motion Sensor Sensitivity
Voice Prompt
“Motion sensor sensitivity”
Factory Default Low
Level Adjustment
Rotate the Jog Dial
(High/Low/Disable)
Apply Tap the Phone Button
Motion Sensor Sensitivity determines the sensitivity when you double
tap on the surface of the 20S EVO to enter voice command mode.
Rotate the Jog Dial until you hear the voice prompt, “Motion sensor
sensitivity”. By tapping the Phone Button, it will lead you to level
adjustment mode. Default is at low, but you may change it to high, or
disable the feature by rotating the Jog Dial. After you have completed
the setting, tap the Phone Button to apply the changes. If this feature
does not work properly, disable this feature, and press on the Ambient
Mode Button to enter voice command mode.
21.8 Enabling/Disabling Voice Activated Phone Answering
Voice Prompt
“VOX phone”
Factory Default Enable
Enable Tap the Phone Button
Disable Tap the Jog Dial
If this feature is enabled, you can answer incoming calls by simply
saying a word loudly enough, unless you are connected to intercom.
For example, when you hear a series of beeps for an incoming call,
you can answer the phone by saying “Hello” or any other word loudly.
However, the VOX Phone feature does not work if you are connected
to the intercom. This feature is enabled from the factory but can be
disabled through the conguration menu, Device Manager, or the
Sena Smartphone App. If this mode is disabled, you have to tap the
Jog Dial or the Phone Button to answer an incoming call.