EasyManua.ls Logo

Sena ACS 10 - Audio Settings; Voice Control & Prompts

Sena ACS 10
41 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ACS10 Motorcycle Bluetooth
®
Communication System | 36
10 CONFIGURATION SETTING
10.2.1 Unit Language
You can select the device language. The selected language is
maintained even when the headset is rebooted.
10.2.2 Audio Equalizer (Default: Off)
You can use the Audio Equalizer to increase/decrease the decibel level
of different frequency ranges of audio.
• Balance will adjust all of the frequency ranges to be the same volume
level (0 dB).
• Bass Boost will increase the bass range of audio (20 Hz-250 Hz).
• Mid Boost will increase the mid range of audio (250 Hz-4 kHz).
• Treble Boost will increase the high range of audio (4 kHz-20 kHz).
10.2.3 Audio Source Priority (Default: Intercom)
Audio Source Priority allows you to select the priority between
the intercom and music (which includes GPS app instructions and
message notifications) from a smartphone. If the intercom is selected
as the Audio Source Priority, your music will be interrupted during
an intercom conversation. If music is selected as the Audio Source
Priority, intercom conversations will be interrupted while your music is
heard.
Note: Audio Source Priority is active only when Audio Multitasking
is disabled.
10.2.4 VOX Phone (Default: Enable)
If this feature is enabled, you can answer incoming calls by voice. When
you hear a ringtone for an incoming call, you can answer the phone
by saying a word such as “Hello” loudly or by blowing air into the
microphone. VOX phone is temporarily disabled if you are connected
to intercom. If this feature is disabled, you have to tap the Center
Button to answer an incoming call.

Table of Contents