SENAO SN-258 PLUS - Features Setting; Setting the Base Unit; Setting Pause Duration; Setting Dialling Mode

A. Setting the Base Unit
N : Inter-digital-time of DTMF dialling mode
5 : 140 ms
6 : 200 ms
7 : 70 ms
8 : 100 ms (default)
: 400 ms : 700 ms
: 200 ms 5 : 500 ms : 800 ms
The parameters of base unit are set through the handset. First, press
on handset and make sure that the intercom is established.
1. Setting PAUSE duration
0 1 N MEMO
(handset) (N: 1~4) store
N : PAUSE duration
1 : 2 seconds 3 : 4 seconds
2 : 3 seconds 4 : 6 seconds (default)
2 Setting dialling mode
0 2 N MEMO
(handset) (N: 1~8) store
N : Speed of pulse dialling mode
1 : 20 PPS 40/60
2 : 20 PPS 33/67
3 : 10 PPS 40/60
4 : 10 PPS 33/67 (default)
3 Setting flash duration
0 3 N MEMO
(handset) (N: 1~9) store
N: flash duration
1 : 100 ms 4 7
2 8
3 : 300 ms 6 : 600 ms (default) 9 : 900 ms
Setting Features
27-EN