C. Checking the handset's ID number
While in stand-by mode, the LED array indicates the ID of handset.
D. Checking the parameters
While in multi-handset system, please check the parameters set in the
handsets and the base unit.
1. Each handset has an individual ID. It is not allowed that two handsets
have the same ID.
2. The max. handset's ID number is suggested to be as same as the
parameter "max amount of handsets ID registered to one base".
(1) To change the ID of handset, refer to P. 29.
(2) To reset the parameter "max. amount of handsets registered to one
base", refer to P. 28.
LED status LED status Handset number Handset number
B. De-registering handset
below
When a registered handset code needs to be de-registered, follow
steps.
1. If the handset is power on, press and hold about 3 seconds to
turn it off.
2. Press and hold MEMO and about 3 seconds, a tone
" bi-bi" sounds.
32-EN
To Next Page
Loading...
