Need help?Do you have a question about the Senco PC0781 and is the answer not in the manual?
Wear OSHA-approved eye protection, hearing protection, and hard hats for overall safety.
Use only clean, dry air, not exceeding 125 psig/8.4 BAR, and ensure compliant compressors.
Use correct air hoses/couplings and disconnect air before maintenance or transfer.
Ensure tool is in good condition, use Senco parts, and handle safely.
Drive fasteners into work surface only and maintain a stable position.
Never use a leaking tool and maintain a firmly balanced position while operating.
Read safety warnings before using the tool or performing maintenance.
Hold the tool correctly, position the nail, and gently push to activate for driving.
If dropped, reset the internal valve by slapping the cap to restore operation.
Adjust fastener depth by adding/removing spacers or changing air pressure.
Perform daily inspections, ensuring all screws are tight to prevent unsafe operation.
Apply Senco pneumatic oil (1-2 drops) into the air inlet twice daily.
Wipe the tool clean daily and inspect for wear using non-flammable solutions.
Use the provided steps and chart to set proper air pressure and nail depth for best results.
Details one-year warranty for repair/replacement, conditions, exclusions, and liability limits.
Explains replacement policy for tools destroyed by Acts of God, requiring proof of ownership.
Wear OSHA-approved eye protection, hearing protection, and hard hats for overall safety.
Use only clean, dry air, not exceeding 125 psig/8.4 BAR, and ensure compliant compressors.
Use correct air hoses/couplings and disconnect air before maintenance or transfer.
Ensure tool is in good condition, use Senco parts, and handle safely.
Drive fasteners into work surface only and maintain a stable position.
Never use a leaking tool and maintain a firmly balanced position while operating.
Read safety warnings before using the tool or performing maintenance.
Hold the tool correctly, position the nail, and gently push to activate for driving.
If dropped, reset the internal valve by slapping the cap to restore operation.
Adjust fastener depth by adding/removing spacers or changing air pressure.
Perform daily inspections, ensuring all screws are tight to prevent unsafe operation.
Apply Senco pneumatic oil (1-2 drops) into the air inlet twice daily.
Wipe the tool clean daily and inspect for wear using non-flammable solutions.
Use the provided steps and chart to set proper air pressure and nail depth for best results.
Details one-year warranty for repair/replacement, conditions, exclusions, and liability limits.
Explains replacement policy for tools destroyed by Acts of God, requiring proof of ownership.
To Next Page
General