Sennheiser AMBEO Max - Starting Room Calibration

Putting the AMBEO Soundbar | Max into operation
AMBEO Soundbar | Max | 31
Disconnecting from the power supply system
▷ Disconnect the power plug of the power cable from the wall
socket.
▷ Unplug the plug of the power cable from the POWER socket on
the Soundbar.
Starting the room calibration
The room calibration is necessary for the measurement of the room
in order to let you get the optimum spatial sound experience.
Therefore, the room calibration should be performed when
• the Soundbar is put into operation for the first time in a room,
• the position of the Soundbar has been changed,
• a subwoofer has been connected or disconnected,
• the room has been changed (e.g. furniture has been moved).
Preparations for calibration
▷ Connect the Soundbar to the power supply system (> 30).
The Soundbar switches on. This process takes about 15 seconds.
The
status LED pulses white.
▷ Press the on/off button on the top of the Soundbar or the on/off
button on the remote control.
The display shows “Hello” and the prompt “Set up microphone”.
AUX IN
SW PRE OUT
OPT IN HDMI 3 IN HDMI 2 IN HDMI 1 IN
HDMI TV (eARC) OUT
ETHERNET USB
POWER
If the “Dolby Virtualizer” is activated, you cannot perform a
room calibration. If necessary, deactivate the “Dolby Virtual
-
izer” in the Smart Control app (> 48).
Hello!
15s
1x
Press
On/Off