EW-DX EM 2 rack receiver
132
System -> TX Update menu item
This menu item lets you perform a firmware update for the
transmitters. This update is recommended after you perform a
firmware update for the receiver (see „Updating the firmware
of the receiver“).
The f i r mwar e ver si ons curr entl y i nst all ed on t he connect-
ed transmitter can be viewed under the TX Software menu
item for the respective channel (see „Ch 1 / Ch 2 -> TX
Software menu item“).
To open the TX Update menu item:
▷ In the System menu, navigate to the TX Update menu item.
▷ Press the jog dial to open the menu.
The available sender firmware is displayed:
▷ Press the jog dial to start the firmware update.
▷ Press the SYNC button on the connected transmitter for
3 seconds.
To Next Page
Loading...
