Sennheiser Set 860 - Connecting the Transmitter to the Power Supply System

Putting the Set 860 into operation
14 | Set 860
Connecting the transmitter to the power supply
system
1 Connect the connector of the power supply unit to the
yellow socket of the transmitter.
2 Select a suitable country adapter and slide it onto the
power supply unit until it clicks audibly into place.
3 Plug the power supply unit into the wall socket.
All LEDs on the transmitter light up for 5 seconds. The
transmitter is in standby mode.
US
EU
UK
AU
2
1
3
Power
1A
1
A