Sennheiser Set 860 - Page 8

Product overview
8 | Set 860
Overview of the Transmitter status LED
Overview of the acoustic signals/beeps
Transmitter status LED The transmitter...
– ... is in standby mode.
lights up white
... and the stethoset receiver are
connected. The speech intelligi-
bility function is deactivated (see
page 27).
lights up blue
... and the stethoset receiver are
connected. The speech intelligi-
bility function is activated (see
page 27).
flashes blue and white
... has detected an incompatible
digital audio signal (see page 11).
The LEDs on the transmitter indicate the current operat-
ing state. If you are not pressing any button on the ste-
thoset receiver or the transmitter, the LEDs automatically
dim after approx. 30 seconds to not disturb you.
Beeps Meaning
during operation,
2 beeps
The rechargeable battery is almost
empty, recharge the rechargeable
battery (see page 15).
during operation, no
audio transmission,
5 beeps
The receiver is outside the trans-
mission range (see page 44).
when changing the
volume
The maximum or minimum volume
is reached (see page 22).
when changing the
balance setting
The maximum or minimum balance
setting is reached (see page 23).