Using the transmitter
17
왘 Store the frequency bank and channel
setting by pressing the jog dial on your
transmitters. You can carry out the Sync
function (see right-hand column) at a
later time to establish a transmission link
between transmitters and receivers.
OR:
왘 Immediately synchronize your receivers
with your transmitters by carrying out the
Sync function (see right-hand column).
This establishes a transmission link
between transmitters and receivers.
The icon in the left lower corner of
the transmitter display indicates that the
Sync function can be carried out.
–
–
To cancel the transfer:
왘 Press the STANDBY button on the trans-
mitter.
“ ” appears on the display panel of the
transmitter. “ ” also appears if no suit-
able receiver was found.
Easy Setup Sync Sync
To Next Page
Loading...
