Sensaphone 800 - Page 25

Sensaphone
®
Model 800 User’s Manual
24
6WDUWLQJWKH0RGHO
When the DC power transformer is first plugged into the
ELECTRICALOUTLETTHE-ODELAUTOMATICALLYSTARTSIN25.
MODE4HESystem OnLIGHTWILLBEGINTOGLOW4HEUNITWILL
RESPONDWITHh(ELLOTHISIS3ENSAPHONEv
5XQ0RGHDQG6WDQGE\0RGH
0RESSINGTHE25.34!.$"9KEYONTHE-ODELKEYPAD
will alternately activate or deactivate the unit. If the unit is
ACTIVATEDANDIN25.MODETHESYSTEMONLIGHTGLOWSSTEADILY
)N34!.$"9MODETHESYSTEMONLIGHTGOESOUTBUTWILLBLINK
every few seconds to indicate that power is still supplied to the
unit.
)N25.MODETHE-ODELISABLETORECEIVEINCOMINGCALLS
and to dial out automatically in the event of an alarm on one of
THEMONITOREDCONDITIONS4OENTER34!.$"9MODEPRESS25.
34!.$"9
!SSOONASTHE-ODELENTERS34!.$"9MODEITRESPONDS
WITHh'OODBYEv4HESYSTEMONLIGHTIMMEDIATELYGOESOUT
and then resumes with a blink every few seconds. While in
34!.$"9MODEALLFUNCTIONSAREDISABLEDBUTPROGRAMMED
MEMORYISPRESERVED5PONEXITING34!.$"9MODEANY
CURRENTLYEXISTINGALARMSWILLBEANNOUNCED
NOTE
34!.$"9MODEISNOTEQUIVALENTTOhPOWER
off”—an electrical source, such as the 120 VAC, or
the battery backup, continues to provide full power
TOTHEUNIT)FTHEUNITISPLACEDIN34!.$"9MODE
unplugged from the 120 VAC outlet, and placed
in storage, the batteries will continue to power the
Model 800, discharging until they fail. Consequently,
batteries should always be removed from the unit fol
lowing disconnection from any 120 VAC outlet, prior
to storage.
0RESSTHE25.34!.$"9KEYAGAINTORETURNTO25.MODE
RUN
STANDBY
)LJXUH7KH58167$1'%<.H\