Sensaphone 800 - Chapter 4: Communications Programming

Chapter 4: Communications Programming
41
7RSURJUDPWKH,'0HVVDJH
0RESSTHE3%4KEY
SET
0RESSTHE-%33!'%KEY4HEWILLSAYh%NTER-ESSAGE
.UMBERv
MESSAGE
0RESSTHE)$KEYNUMBERKEY
0
ID NUMBER
POWER
4. When the unit beeps, begin speaking your message into the
MICROPHONE4HEUNITWILLSAYh/+vWHENTHERECORDING
time has elapsed; then it will play back your recorded
message. You can shorten the message length by pressing
THE%.4%2KEYAFTERSPEAKINGYOURMESSAGE
7RSOD\EDFNWKH,'0HVVDJH
0RESSTHE7(!4)3KEY
WHAT
IS
0RESSTHE-%33!'%KEY
MESSAGE
0RESSTHE)$KEYNUMBERKEY
0
ID NUMBER
POWER
4HEWILLPLAYBACKYOURRECORDEDMESSAGE
4HEZone Messages are used to identify the device or condition
being monitored such as temperature, humidity, equipment
alarms, security alarms, etc.