Sensaphone 800 - Page 89

Sensaphone
®
Model 800 User’s Manual
88
you may acknowledge the alarm with the code “555” if you are
USINGA4OUCH4ONE
 telephone.
s 4OENTERhvPRESSTHENUMBERKEYONTHE4OUCH4ONE

PHONEKEYPADTHREETIMES4HE-ODELWILLRESPOND
“Alarm Acknowledged.”4HE-ODELWILLHANGUPANDTHE
DIALOUTSEQUENCEINCLUDINGANYFURTHERRESPONSETOTHEALARM
will be cancelled.
s )FYOUENTERTHEWRONGCODEORDONOTENTERITWITHIN
seconds following the conclusion of the message, the Model
800 will respond: “Error, Enter Acknowledgement code.”
If you do not enter the acknowledgement a second time the
UNITWILLSAYhERRORvTHENhGOODBYEvANDHANGUP4HEALARM
is still not acknowledged until you call back. You have a
PERIODEQUALTOTHEPROGRAMMED)NTERCALL4IMETOCALLTHE
unit back and enter the “555” acknowledgment code. If you
are calling from a pulse or rotary telephone, refer to Callback
!CKNOWLEDGMENT3ECTIONBELOW
&DOOEDFN$FNQRZOHGJPHQW
Callback Acknowledgement is a feature that allows you to
ACKNOWLEDGEANALARMWITHOUTENTERING4OUCH4ONES
4HIS
feature is disabled by default and must be enabled by entering
the key sequence below. When Callback Acknowledgment is
enabled, simply call the unit back and allow the line to ring 10
TIMES4HEUNITWILLTHENANSWERTHECALLANNOUNCETHEALARM
THENSAYh!LARM!CKNOWLEDGEDv4HISINDICATESTHATTHEALARM
has been acknowledged.
4OENABLEORDISABLE#ALLBACK!CKNOWLEDGEMENT
 0RESS3%.3/2/./&&
SENSOR
ON/OFF
 0RESS34!453
STATUS
4HE-ODELWILLSAY“Callback Acknowledgement Enabled”
to indicate that Callback Acknowledgment is Enabled, or
“Callback Acknowledgement Disabled” to indicate that Callback
!CKNOWLEDGEMENTIS$ISABLED4HISMETHODOFREMOTEALARM
acknowledgment works with any telephone: pulse, rotary, or
4OUCH4ONE.