Sentry Sample Sequencer 5 - Page 23

Sentry Equipment Corp | Sample Sequencer

5
SPD 5.5.15 17
5.2.2 Password Entry Screen
Figure 7: Password Entry Screen
If password protection is enabled, the Password Entry Screen will be displayed when the user
attempts to enter the Control Screen. Enter the correct password to gain access to change the
setting on the Sample Sequencer. The password can be changed by touching the password
widget on the Widget Screen. If you do not know the password, please contact Sentry
Equipment Corp.
5.2.3 Control Screen
The Control Screen is used for changing the state of the sequences. This screen contains the
name and the state of each active sequence.
Figure 8: Control Screen
Depending on your settings, there can be one or two sequences displayed on the Control
Screen. Touching the indicator next to each sequence will turn the sequence on or off.
Touching the wrench button in the lower right hand corner of the screen will take you to the
Widgets.