Sentry Sample Sequencer 5 - Page 56

Sentry Equipment Corp | Sample Sequencer

5
50 SPD 5.5.15
6.6 Starting Up the Sample Sequencer
1. Ensure the Sample Sequencer is securely mounted.
2. Wire the Sample Sequencer to the analyzer, sample valves, and other devices as
described in the Installation section of this manual.
3. Apply power.
4. Setup the Sample Sequencer as required for your application. This includes setting the
sample timers, operating mode, analog input ranges, and custom sequence. Refer to the
Quick Start Guide and Operation sections of this manual.