Commissioning 8
After the filter has been installed in accordance with chapture 7, it can be put in operation.
1. Make sure that a filter element is inserted in the filter and check if all the openings of the
filter are sealed.
2. Rotate the drain valve several times to ensure that no contamination blocks closing of the
drain. Make sure that the drain valve is engaged in "closed" position.
3. Lay rags out to hold small amounts of fuel.
4. Open, if available, the shut off valve before the filter.
5. Loosen the bleed screw cautiously about 1-2 turns. Never turn the screw all the way out!
6. For priming of the fuel system use fuel priming pump.
7. Once the first small amounts of fuel come out of the bleed screw, tighten the screw again
(observe the tightening torque, see chapture 9.1).
8. Turn hand priming pump in flow position
9. Start the engine.
To Next Page
Loading...